![]() Normal wires are barely wrapped in wire and I have always assumed that waterproof wires were just wrapped in the non-conductive material more than the normal, market brand, wires. I have always thought that the way to waterproof a wire was to simply wrap it very thickly in a non-conductive material, such as rubber. It will always be a stronger rubber or non-conductive material than a normal wire, so it can either withstand being submerged underwater or simply allow basic splashes of water to be thrown on it without a short occurring. There is a little more that goes into a waterproof wire than simply wrapping it in more rubber. Waterproof wire nuts are filled with moisture resistant materials such as silicone, grease, or petroleum to prevent corrosion of the exposed wire ends. This is why the wires are usually made with a rubber or non-conductive material that is a little stronger and will not fray.Īlso, the wire has to be made in such a way that no moisture whatsoever will get into the wire and cause a short or failure. The wires that are wrapped have to be wrapped in such a way that they are not too bulky and also not be too heavy that they will hang and possible be a hindrance to its job. With wires that are underwater all the time it makes sense to wrap more rubber around, keeping in mind that it has to be wrapped tight to prevent moisture and condensation from getting in.Īugust 15, - That does make sense, however, there is a little more to it than that. By doing so you make sure that the wire will not short if it happens to be in a damp place.įor heavy, underwater wires it makes sense to use a stronger type of rubber, but to also wrap more rubber around the wire to be sure that a problem does not occur. The way to properly waterproof a wire is to use the appropriate rubber, so that it does not fray over time and to also make sure that it is tightly secured so that absolutely no moisture is able to pass through. ![]() The growing complexity of work vehicles brings greater risk of electrical problems as wiring and. 12-10 Marine Grade Solder Seal Wire Connectors Waterproof Wire Connectors. I understand how at first it makes sense that in order to waterproof a wire one simply has to put more rubber on it, however, this is not the way to go about water proofing something that allows electricity to pass through something it should not. 8 Electrical Supply Tips for Work Truck Fleets. SPECIFICATIONS SKU:HX1030 Shrink Ratio:2:1 Waterproof Level:IP67 Operating. August 16, - You are completely right with that assumption.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |